So basically I’ve ran a batch of sweeps and created a report on it. All fine.
Now I’m planning to run a second batch of sweeps and would like to integrate them into the same report, but use new plots. Right now, both sweep batches would be put into the same plot. However, I can’t find any information about filtering on a plot level.
Thanks!
PS: I’m using the UI
Hi Tim,
For your workflow, there seem to be 2 different workarounds. Either attaching different tags to runs that are from different sweeps. Or, you could have a different naming scheme for runs from different sweeps.
That way you can filter what shows up in your table and graphs in reports.
Warmly,
Artsiom
Hi there, I wanted to follow up on this request. Please let us know if we can be of further assistance or if your issue has been resolved.
Hi Tim, since we have not heard back from you we are going to close this request. If you would like to re-open the conversation, please let us know!
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.